Protect your Toyota Tundra 4x4 and Sequoia 4x4 with our 3/16" aluminum Cat Shield™. Our three piece design is a drill-less installation that provides the best deterrence on the market. The 3/16" aluminum offers the highest level of protection (settle for nothing thinner) and weight savings versus other metals. We look at every detail of our products to make sure you are protected!
- We use tamper-proof screws in all our mounting points. These are a patented design that you cannot purchase off the market. They are not the same as other companies that claim to use tamper-proof screws when they are just using common 6 lobe torx screws.
- Our shield wings are installed with tamper-proof screws that are recessed in the shield so that no one can remove the wings by cutting off the screw head.
- Our shield is thick enough to act as a skid plate and protect your vehicle from rocks and debris.
Our Fitment Commitment. There are hundreds of variations of Tundras and Sequoias that this product may fit. While we do our best to test and verify every model, it is impossible to know for sure. We guarantee that if our shield does not fit (and you purchased the right shield for your vehicle), we will give a full refund and return shipping on the product. If you ever have any issue, take a picture of it, contact us, and we will do our best to help you out.
REQUIRED TOOLS FOR INSTALLATION. Rivet Nut Tool with M6 Mandrel/Head, 1/4" bit driver, 12mm open wrench. Installation Guide
*Professional installation recommended.
FREE SHIPPING IN THE CONTINENTAL US! Info on expedited shipping options.
Pretty easy install and looks great. I highly recommend this cat cage. Seen others but the beefy plates is what sold me. I had my catalytic stolen before and waited 6 weeks to get my truck back. So during the wait I ordered the Miller cat. I hope I never need it again but if I do, it's on there!!!!
Had shield installed on my Sequoia last week at Toyota dealer, took them less than 30 minutes. They sent me photos when it was up on lift. Well designed product great fit and finish.
Well made and a perfect fit. Went together as expected. I used red lock tight on the wing portion. And torque as required, aluminum is easy to over torque. They cover the front cats completely and the front portion of the rear cats. I decded to etch the cats with my info before installing the shield to add further deterrent to any would be thief’s. For 4x4 tundra’s they recommend lifting the transmission to insert the rivet nut. I used a YouTube hack with a bolt that worked just fine and was far better than trying to loosen the transmission and lifting it. The install is easier if you lift the vehicle six to eight inches. Over all a piece of mind and a good investment in my opinion. Also so far no road noise and no heat issues. I wish they offered the option for spare hardware. And the ability to add pictures on the review, it is harder than the install.
Thanks for your review and comment. Depending on your set up, the lifting of the transmission can be done with a jack and wooden block to give you just enough clearance to install the rivet nut. But do share that youtube clip and we will see if we can add such info in the instructions. As for spare hardware, we try to maintain as much control over the hardware to keep them out of the wrong hands. But if for any reason you need extra hardware, don't hesitate to contact us. We have a protocol of verifying any hardware requests and can send you a custom link where you can order them. Sorry that the uploading of images was difficult! We will see if the app we use needs to be fixed.
Great fit if you don’t have a lift
Great product however I'm with everyone else. I wish it covered the rear Cats. Other than that it's great quality and serves a great purpose thus far!