Protect your Toyota Tundra 4x4 and Sequoia 4x4 with our 3/16" aluminum Cat Shield™. Our three piece design is a drill-less installation that provides the best deterrence on the market. The 3/16" aluminum offers the highest level of protection (settle for nothing thinner) and weight savings versus other metals. We look at every detail of our products to make sure you are protected!
- We use tamper-proof screws in all our mounting points. These are a patented design that you cannot purchase off the market. They are not the same as other companies that claim to use tamper-proof screws when they are just using common 6 lobe torx screws.
- Our shield wings are installed with tamper-proof screws that are recessed in the shield so that no one can remove the wings by cutting off the screw head.
- Our shield is thick enough to act as a skid plate and protect your vehicle from rocks and debris.
Our Fitment Commitment. There are hundreds of variations of Tundras and Sequoias that this product may fit. While we do our best to test and verify every model, it is impossible to know for sure. We guarantee that if our shield does not fit (and you purchased the right shield for your vehicle), we will give a full refund and return shipping on the product. If you ever have any issue, take a picture of it, contact us, and we will do our best to help you out.
REQUIRED TOOLS FOR INSTALLATION. Rivet Nut Tool with M6 Mandrel/Head, 1/4" bit driver, 12mm open wrench. Installation Guide
*Professional installation recommended.
FREE SHIPPING IN THE CONTINENTAL US! Info on expedited shipping options.
The shield arrived with no hardware, however, contacted support, hardware sent immediately. Upon receiving hardware, it was missing the nut plates. Contacted support, nut plates plates sent immediately. Finally got to install the shield. Upon trying to install M6 rivet nuts, the hole on the Tundra crossmember was too small. Had drill hole to next size to fit 12mm or 11/32. Installed rivet nut with no problems after that. Went to put the 12mm open/box end wrench on nut, did not fit, it was actually 13 mm. Instructions need updated, minor bump for those mechanically inclined. I would feel better if front nut plate had locking castle nut. May install one afterwards. Fit wise, the shield matched up perfectly to mounting locations.
But, once said, done and installed, the shield should do its job to keep the converters under the truck. Right now I hear at the dealship the converter wait is 2 months, due to all the thefts here in the greater Houston, TX area and no parts available.
Upon final shipment of hardware, $20 refund on purchase price, good customer service.
I recommend the product highly.